Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it’s a question worth raising with a supplier before you buy, such as welding tables UK.
A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, oil or an undersized compressor, is one of the most common causes of poor TEC Products cut quality and shortened consumable life, so it’s worth checking a machine’s air requirements against what your compressor can actually deliver before you buy, not after.
Duty cycle is one of the most misunderstood figures on a welder’s spec sheet, yet it tells you more about real-world usability than the headline amperage does. It’s expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.
Flap discs sit between cutting and grinding in terms of use, combining overlapping abrasive flaps to blend welds, remove coatings and finish surfaces with more control than a solid grinding disc. Every disc also carries a maximum operating speed printed on it by the manufacturer, and checking this against your angle grinder’s rated speed is a basic habit worth building into every new batch you open.
If you’re weighing up options for your own workshop, from portable units to fixed installations, it’s worth talking through the layout with a supplier who stocks a range of systems, such as plasma cutting equipment.
Shade range and sensor count are the two specifications that matter most in daily use. A wider variable shade range lets one helmet cover a broader spread of processes and amperages, from low-amp TIG work through to higher-output MIG or MMA, without swapping cartridges. More sensors generally mean the filter is less likely to miss a low-angle arc or a strike caught at an awkward viewing angle, which matters most for TIG welding where the arc can be harder for a sensor to pick up cleanly.
