Duty cycle is one of the most misunderstood figures on a welder’s spec sheet, yet it tells you more about real-world usability than the headline amperage does. It’s expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.
Budget for a first machine is rarely just the welder itself. A gas cylinder and regulator for MIG or TIG, a decent auto-darkening helmet, gloves and basic workshop ventilation all add to the real cost of getting started, and skimping on the supporting equipment tends to cost more in frustration than it saves in cash. It’s worth pricing the whole set-up before settling on a machine at the top of the budget.
A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they’re made from and what they’re used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
TIG welding supplies relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn’t melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.
Portability and power supply matter as much as the process itself. A stick welder will run from a generator or a domestic supply in places a gas bottle can’t easily follow, while MIG and TIG set-ups need a gas cylinder and, for anything beyond light-gauge work, a heavier electrical supply. Workshop layout, the materials you weld most often, and how frequently the machine needs to travel are all worth weighing up before settling on one process.
